Filter
Top Products
Getting Started
14
Using an Audiovox
®
Receiver with
Delphi Premium Sound System
1. Install the Audiovox cradle onto the Delphi Premium Sound System. In-
sert the Audiovox receiver (sold separately) into the cradle insert included
with the system until snug.
Caution: Do not use excessive force when inserting the receiver into the
cradle. Doing so could cause damage to the unit.
2. Place the cradle insert containing the Audiovox receiver into the cradle by
first pressing in on the back of the black inset cradle in the system. Then
let the cradle tilt forward, carefully slide the cradle insert down into the
tray so that the alignment tabs on the sides of the tray line up with the
slots on the cradle insert and the connector is completely seated. Push
on the top center above the display of the cradle insert so that it tilts back
into the system until a click is heard. The Audiovox receiver cradle insert
can be removed by reversing this process.
3. Power up the Delphi Premium Sound System by using the power button
on the receiver or on the remote control. If the display reads “ANTENNA”
after powering up, check that the antenna connection is secure and com-
pletely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the
receiver is not activated yet). If the “ANTENNA” message remains, power
down the radio, unplug the antenna and look for any obvious damage in
the connector, jack or antenna cable. If no damage is detected, reconnect
the antenna, turn the unit back on and change channels again. If the mes-
sage still appears, contact your retailer.