Filter
Top Products
7
Getting Started
Power Up the System
Use the power button on the receiver or on its remote control to turn on
the receiver. If the display reads “ANTENNA” after powering up, check that
the antenna connection is secure and completely pushed in. Next, change
channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet).
NOTE: Some receivers will power up automatically when installed in the
Delphi Premium Sound System.
If the “ANTENNA” message remains, power down the radio, unplug
the antenna and look for any obvious damage in the connector, jack or
antenna cable. If no damage is detected, reconnect the antenna, turn the
unit back on, and change channels again. If the message still appears,
contact your retailer.
If the display reads “NO SIGNAL” after powering up, follow the instructions
in “Setting up the Antenna” on page 5.