Filter
Top Products
9
current going to it will reactivate itself with a pop when AC current is
restored, which is normal.
Please note that after the cessation of a signal, it may take up to an
hour for the amplifier to actually turn off from active to standby mode.
In some instances, because of RF presence in your area, the red LEDs may
not turn off. However, this is nothing to be concerned about as the amplifiers
draw almost no power when they are idling.
When using the ProSub with Definitive ProMonitors, please consult
your ProMonitor instruction manual for specific information regarding
hookup, wiring and placement.
Setting the Level and Crossover Frequency When Using
the Pr
oSub with Pr
oMonitors
When you have the ProMonitors wired to the speaker level outputs
on your ProSub, the following are our suggestions for starting settings
on your controls. Remember, these are just approximate settings and we
suggest experimenting to determine the best-sounding settings for your
particular set-up.
1.
Set the variable low pass crossover control on
the back of the ProSub to approximately 2
o’clock. Please note that the exact frequency
will depend on many factors including specific
positions of the speakers in the room, so you
might experiment with a slightly higher or
lower setting to achieve ideal blending
between the sub and the satellites for your
particular set-up. Listen to a wide variety of
music to determine the correct setting for this
in your system.
2.
Set the subwoofer level control to 12 o’clock.
Please note that the exact level depends on
many factors including your room size,
position of the speakers, etc. as well as your
personal listening taste, so you might
experiment with the subwoofer level while
listening to a wide variety of music until you
achieve the ideal setting for your system.
Using the ProSub with Definitive ProMonitors