Filter
Top Products
Low Level Connections
One way to hook up your Definitive Technology ProSub 60 sub-
woofer is via the low level input connectors which are RCA-type jacks
designed to accept standard audio interconnect cables. For preamps and
decoders, run an interconnect from the left and right outputs of the pre-
amp or decoder to the left and right low level inputs on the subwoofer. If
you have two sets of outputs, you can use one set of these; if not, you
can put a Y-connector into each output (left and right) and run half of
each Y back into a (left and right) main input on the preamp decoder,
receiver or power amp and the other half into the (left and right) low
level input on the subwoofer.
Additionally, many new model receivers, preamps and decoders fea-
ture a mono (line level) output intended to be used with subwoofers. You
can feed the mono or LFE subwoofer output of your receiver or decoder
to the LFE low level input on the subwoofer and achieve full perfor-
mance. Often these outputs have their own low
pass filter built into the
circuit. If you use these outputs, this low pass filter will work in
conjunction with the low pass filter found in the ProSub 60 subwoofer to
Wiring Diagrams
5