Filter
Top Products
degrade the stereo image. Use your judgement as to what location best fits your preferences. We rec-
ommend that the speakers be kept at least 24" from the rear wall and 36" from the side wall for optimal
imaging.
RIGHT
FRONT
LEFT
FRONT
CENTER
CHANNEL
LEFT
REAR
RIGHT
REAR
LISTENING AREA
45
RIGHT
FRONT
LEFT
FRONT
CENTER
CHANNEL
LEFT
REAR
RIGHT
REAR
LISTENING AREA
LEFT
REAR
RIGHT
REAR
LISTENING AREA
LEFT
FRON
T
RIGHT
FRON
T
CENTER
FRON
T
SUBWOOFER
(OPTIONAL)
RIGHT
FRONT
LEFT
FRONT
LISTENING AREA
45
HOOK UP
Use 16 gauge or heavier speaker wire for connecting to your amplifier or receiver. Cut wire lengths leav-
ing an extra 12” to 24” at each end to allow for moving the speaker or receiver.
Using a wire cutter or a sharp knife, strip 1/2” of insulation off each end of the wire to expose the conduc
-
tor. Twist wire ends to prevent from fraying. Connect the conductors to the binding posts on the bottom
or back of the speaker by unscrewing the post enough to expose the hole in the terminal post. Slip the
exposed conductor in the hole and tighten the post. Repeat this step for connecting to your amplifier or
receiver. Refer to the owner’s manual supplied with your electronics to assist with proper hook up.
Note: To ensure proper performance, make sure that the wire from the red (+) terminal on
the speaker is connected to the red (+) terminal on your amplifier or receiver. Likewise, make
sure the wire from the black (-) terminal on the speaker is connected to the black (-) terminal
on the amplifier or receiver. (Figure 5)
POWER AMPLIFIER
FRONT
R L
-
-
++
+
+
+
Figure 1- Typical Home Theater Loudspeaker Placement
Figure 2- Alternate Home Theater Loudspeaker Placement
Figure 3- Typical Multi-Channel Audio Loudspeaker Placement
Figure 4- Typical 2 channel Stereo Loudspeaker Placement
Figure 5
NOTES