Filter
Top Products
POWER OUTPUT 10% THD(RMS)
TOTAL HARMONIC DISTORTION
S/N RATIO DOLBY
FREQUENCY RESPONSE
Power supply
Voltage ( Option )
AC 110V ~ 127V or
220V ~ 240V (50/60Hz)
Power consumption Standby 2.8Watt
Operating 90Watt
Dimensions (W x D x H) / Weight 430 x 380 x 55 mm / 6.7 kg
POWER OUTPUT at 10% THD(RMS)
THD(Total Harmonic Distortion)
Input Sen. / Impedance @ 1KHz, 47K ohms
Output Level/Impedance @ 1KHz
Frequency Response(Analogue)
S/N Ratio IHF-A Weighted
Subwoofer Turnover Frequency
Channel Separation
At 1KHz, 6 ohms
At 1KHz, 10W
VIDEO
Tape Rec
at 1W : VIDEO -3dB
VIDEO
1KHz
50W
0.1%
200mV
30mV/47K
200mV
30mV/2.2K
20Hz~20KHz
70dB
120Hz
55dB
Front Amp. Section
Rear Amp Section
Center Amp Section
Video Section
Input Sen./Impedance
Output Level/Impedance
Frequency Response
Crosstalk
S/N Ratio
Composite Video(Video)
Composite 75 ohm
S-Video(Y/C) 75 ohm(DVD only)
Component Out(Y/ Cb/ Cr):Option
Ref 500KHz
@1MHz
DVD
1Vp-p/75 ohm
1Vp-p/75 ohm
1Vp-p/ 0.286Vp-p
1Vp-p/0.7Vp-p/0.7Vp-p
45dB
60dB
0.5 dB
0.5 dB
0.5 dB
0.5 dB
5Hz~5.7MHz
40dB
POWER OUTPUT at 10% THD(RMS)
TOTAL HARMONIC DISTORTION
S/N RATIO, IHF-A FILTER
FRE. RESPONSE
At 1KHz, 6 ohms
At 1KHz, 10W
Rated Output
1W
50W
0.1%
70dB
135Hz~18KHz
At 1KHz, 6 ohms
At 1KHz, 10W
Rated Output
1W
50W
0.1%
65dB
135Hz~18KHz
General specifications
Specifications
Woofer Section
POWER OUTPUT at 10% THD
FREQUENCY RESPONSE
S/N RATIO, IHF-A Weight
At 100Hz, 4 ohms
1W
80W
20Hz~150Hz
60dB
FM Tuner Section
(FM ANT Impedance : 75 ohms)
Tuning Range
Scanning
Frequency Interval
Usable Sensitivity,
75 ohms
S/N Ratio @1mV
IHF-A FILTER
USA Version
Australia/Europe Version
USA Version
Australia/Europe Version
S/N=30dB,USA Version
S/N=26dB
,Australia/Europe Version
Mono USA Version
Mono Australia/Europe Version
Stereo USA Version
Stereo Australia/Europe Version
87.5~108.0MHz
87.5~108.0MHz
100KHz
50KHz
2uV(17.2dBf)
3uV(20.8dBf)
70dB
70dB
65dB
63dB
Remedies
• Switch the frequency receiving mode to mono.
• Lower the treble level.
• Adjust the position, height, and direction of the FM
antenna.
• Connect an outdoor FM antenna. Try to use an
antenna with more elements. (For installation of
the outdoor antenna, consult your nearest dealer
as it requires special skills and experience.)
–
–
–
• Insert new batteries.
• Replace with new batteries.
• Point the remote controller at the remote sensor of
the machine.
• Operate the remote controller within 5 m.
Tuner
Remote Controller
Causes
• FM stereo waves may produce a hiss noise
when a certain level is reached.
• The position or direction of the FM antenna is
incorrect.
• The station is too weak.
• The radio wave is distorted.
• Cars are running or airplanes are flying near the
house.
• There is a tall building or a mountain nearby.
[The waves transmitted from the transmission
center (direct waves) and the waved diffracted
by buildings or mountains (diffraction waves)
interfere with each other causing multi pass
distortion.]
• No batteries are inserted in the remote controller.
• The batteries are worn out.
• The remote controller is not pointed at the
remote sensor of the machine.
• The remote controller is too far from the
machine.
Symptoms
Too much noise is heard or sound is
interrupted occasionally. (“STEREO”
indicator does not light steadily.)
Sound is distorted or sound volume
decreases.
Sound is excessively distorted.
The buttons on the machine operate
but the buttons on the remote
controller do not operate.
Troubleshooting
Accessories
Others
42 43
HC-4130
Model
30 W, 6 ohm 50 W, 6 ohm
Same to
“ ” Series
Power output at 10%THD(RMS)
Front/Center
/Rear
Woofer
Remark
Power output Table