Filter
Top Products
Cyberdata VOIP Indoor Paging Speaker SIP device Setup Notes
The following steps show how to program the Cyberdata Indoor Speaker to interconnect with the 3300
ICP.
For more detailed configuration or questions about the Cyberdata Indoor Speaker click on the following
link: http://www.cyberdata.net/support/voip/ceilingspeaker.html
Step 1
Plug network cable into the RJ-45 jack at back of Speaker. The speaker must be plugged into a network
switch port that is supplying Power over Ethernet.
Step 2
The default IP address of the speaker is 192.168.3.10. Press the RTFM button on the front of the speaker
with a paper clip of thumbtack. This should read back its IP address to confirm.
Access the Configuration Portal:
http://192.168.3.10
Username: admin
Password: admin
Step 3
Click “Network Setup”. Set “IP Addressing” to “DHCP” or if you prefer you can use static IP addressing.
When you save settings the speaker will reboot.
Document #
09-5159-00034 Page 13