Filter
Top Products
XLS DriveCore 2 Series Power Amplifiers
page 11
Operation Manual
System Menu
The following features may be accessed through the SYSTEM MENU. The SYSTEM MENU is the fourth selection on the MAIN MENU. Since only three selections are
displayed, you must scroll down using the NEXT button until SYSTEM is displayed and highlighted.
SYSTEM MENU
DISPLAY SLEEP
LIGHTING
SECURITY
INFORMATION
FACTORY RESET
BACK
Additional Features
Display Sleep
The user may configure the amplifier to allow the display to go into a sleep mode after a pre-determined idle time. This feature can be useful in applications where it is
desirable to minimize the light from the amplifier.
This feature may be accessed via SYSTEM > DISPLAY SLEEP. Within the DISPLAY SLEEP menu, the user has the option to set the sleep mode to off or to choose a delay
time of 30 seconds, 1 minute, 2 minutes or 5 minutes. If no menu buttons are pushed and the time period elapses, the display will turn off. It can be awakened by touching
any menu button.
LED Lighting Options
LED lighting Options can be accessed via SYSTEM > LIGHTING. Inside the LIGHTING menu, the user can toggle the on and off of blue panel lights as well as the green
signal level indicators.
Note: The thermal and clip indicators cannot be disabled.
Security
A security feature allows the user to lock the menu buttons so that the settings are not disturbed once they have been set up. To enable the security feature, go to SYSTEM >
SECURITY and press NEXT to toggle the display to ENABLE. Press MENU/SEL to return to the SYSTEM MENU. Once enabled, the user can lock-out the menu
buttons by simultaneously pressing the PREVIOUS and NEXT buttons. The menu will remain locked, even through a power cycle, until the PREVIOUS and NEXT buttons
are pressed again.
System Information
For the audio geeks that just can't get enough data, we have provided a window to access your amplifier's system information. SYSTEM > INFORMATION will reveal a list of
information including the model number, internal temperatures and voltages, firmware release number, etc.
Reset Factory Defaults
There may come a time when you just want to reset the entire system and start your setup from ground zero. If you are sure that you want to do this, you may select
FACTORY RESET from the SYSTEM MENU. If you select YES for factory reset, you will then be prompted to confirm your choice.
WARNING: If you reset your amplifier, all settings will revert to the factory preset values and you will lose all configurations you may have entered for amplifier modes, filter
frequencies, input sensitivity and system settings.