Filter
Top Products
9
The rear satellites may be installed on
their convenient floor stands. While
listening, the stands should be positioned
to the left and right of your listening
position (see Diagram G on the
previous page).
The Floor Stands are small enough
to be stowed underneath a desk when
not in use. See page 11 for floor stand
assembly instructions.
Larger work surfaces can accommo-
date both front and surround pairs of
satellites on their Desktop Stands. Try
the extreme corners of a desk using the
Desktop Stands (see Diagram H).
Also, you may attach the rear
satellites under a desktop or at the
sides of a desk using the hook and
loop fasteners (see Diagram I).
After you have positioned the rear
satellites, use the test sound to make
sure each speaker can be heard
clearly.
The Subwoofer. The subwoofer’s
optimum position is on the floor
against the wall under the computer
desk. The nearer the subwoofer is to
the corner of the room, the stronger
its maximum bass output will be. We
strongly recommend placing the
subwoofer on the floor (see Diagram J).
Leave at least 8 cm (3 inches) of
space between the subwoofer face
and a wall. Small objects in front of,
but not touching the subwoofer (table
legs, for instance) will have no effect
on its sound. If you have no available
floor space, the subwoofer can be
placed on a shelf, desktop or other
sites, but its maximum output will be
reduced. The subwoofer is not
magnetically shielded, so position it
at least 18 inches away from a
computer monitor.
Substituting a powered
subwoofer. You may substitute a
powered subwoofer for the subwoofer
that comes with the DTT2500 Digital.
Connect its line level input (typically
an RCA jack) to the dedicated
subwoofer output on the back of the
Decoder Amplifier, using a shielded
audio cable with RCA plugs on each
end. Refer to the powered
subwoofer’s User Manual for
adjustment procedures.
H I
J