Filter
Top Products
Chapter 6 - Basic Configuration Guide 47
8. Set up VPN Users.
Users are added to the configuration by entering a few unique parame-
ters, and each is assigned to a VPN Group Configuration, configured in
the previous step.
Use edit config to set the parameters in the VPN Users section. All
values are case sensitive.
Example
Edit [ VPN Users ] > append 1
Enter lines at the prompt. To terminate input, enter a . on a line
all by itself.
Append> Rumi Config=basic group config SharedKey=”shish” Auth=”Burnt”
Encrypt=”Kabob”
Append>
Edit [ VPN Users] exit
v Note: The Auth and Encrypt keywords specify STEP/STAMP (Com-
patible System’s proprietary tunnel negotiation protocol) parame-
ters for users. These can be used to allow connections from users
running older versions of the VPN Client software, but is not rec-
ommended for new users.
9. Save the Configuration and download it to the device.
Use the save command to save the configuration and download it to the
device. When asked if you are sure that you want to download the
configuration and restart the device, reply yes. After the IntraPort has
rebooted, users will be able to connect with VPN Client software.
v
Note: Do not turn the IntraPort 2/2+ off during the boot process or it
will lose its operating software.
Example
IntraPort2 # save
Save configuration to flash and restart device? y