Filter
Top Products
II. Source-Output, and Power Connections
The input and output connectors are clearly marked on the rear lip of the top cover. It
is important to remember the correct left or right channel orientation. The function and
channel markings on the rear panel correspond to the front panel controls and their
signal paths.
They are:
1. The BALANCED DISC inputs should be attached to the balanced outputs of a compact
disc player or phono stage. The balanced XLR pin configuration is as follows; ground is
pin 1, positive is pin 2, negative is pin 3.
2. The UNBALANCED DISC, TUNER, and VIDEO input connections are all line level inputs,
requiring only the insertion of the RCA plugs.
3. The RECORDER inputs should be attached to the outputs of the corresponding
recording device; alternately, they may be used as additional line inputs.
4. The RECORDER outputs should be attached to the inputs of the corresponding
recording device.
5. The unbalanced OUTPUTS should be attached to the amplifier inputs either directly, or
through a crossover or processor, as appropriate to the application.
6. The BALANCED OUTPUTS should be attached to the balanced inputs of the amplifier,
either directly or through a crossover or processor, as appropriate to the application. The
balanced XLR pin configuration is as follows; ground is pin 1, positive is pin 2, negative is
pin 3.
7. The AC LINE INPUT should be attached to the power cable provided with the pre-
amplifier. After making the appropriate connections and rotating the level control fully
counter clockwise, insert the three prong safety plug into an appropriate AC power
source. Once the FET PREAMPLIFIER 02b is properly connected, the LED on the front panel
will light. At this point, you may switch on your chosen ancillary components including
the power amplifier.
5
DETAILED INSTALLATION
2
56
7 43
RIGHTRIGHTRIGHTRIGHTRIGHT LEFTLEFTLEFTLEFTLEFTLEFT RIGHT
UNBALANCED DISCTUNERVIDEOINRECORDEROUT
LEFT RIGHT
BALANCED OUTPUT
!
FOR CONTIMUED PROTECTION AGAINST
SHOCK OR FIRE HAZARD,DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
AC LINE INPUT
SEE SERIAL TAG FOR
POWER REQUIREMENTS
~
LEFT RIGHT
BALANCED DISC
UNBALANCED OUTPUT
1