Filter
Top Products
Champion Level 1
USER MANUAL
Page 7 clearaudio electronic GmbH 2006
7. Turn the tonearm into the final position where
the tonearm is almost parallel to the right
hand edge of the chassis. After that you can
fix the tonearm in this position by holding the
tonearm nut with one hand and turning the
tonearm against, while using the other hand
or tight the large nut with a wrench. Mount
the tonearm counterweight.
8. To change the height of the tonearm lift, turn
it up to the high position and loosen the little screw at the front. Now you can move the plate of the
lift. The distance between record and cartridge diamond when it is lifted up should be about 5mm.
Tighten the screw again.
9. Place the belt first round the platter, then round the smaller diameter of the pulley (33 1/3 rpm).
10. The tension of the belt can be changed by turning the motor about its axis. The tension is correct if
the correct turntable speed is achieved within 10 seconds. If the tension is too high, the motor
could start to vibrate a little bit. If the tension is too loose, the turntable will not achieve a
constant and correct speed.
11. Assemble the cartridge according to the
manufacturer’s instructions.
Riemen
Motor
Plattenteller