Filter
Top Products
Champion Level 1
USER MANUAL
Page 6 clearaudio electronic GmbH 2006
4. Place the decuppeling base for the motor in the
indent of the chassis and place the motor on it.
The switch of the motor should be on the
outside of the turntable and the space between
motor and chassis approx. 1cm. (for an exact
adjustment see chapter 4).
5. Please screw the tonearm carefully into the
upper part of the tonearm base. Then slide the
tonearm nut over the tonearmcable and tighten
it, but not too much because the tonearm
should be still able to turn.
6. Now you can While holding the unit you can
adjust the tonearm height (VTA = vertikal
tracking angle) when you have a cartridge
mounted. The VTA is adjusted correctly if the
tonearm sits parallel to the turntable platter
surface after lifting it down. Now loosen the six
screws with the provided hex key wrench, to be
able to set the distance between the spindle
and the tonarm bearing crosspoint to 222mm,
by turning the tonearm base. After that you can
fix the six srews again.