Filter
Top Products
Operations Common to Each Mode
English
29 DXZ388RUSB/DXZ389RUSB/DXZ389RGUSB
● Performing a system check
This function allows you to perform a system
check from the adjust mode when required.
2-1. Select “S-CHECK”.
3-1. Press and hold the [ ] button for 1
second or longer.
“S-CHECK” appears in the display, then
the unit returns to the previous operation
mode.
Entering titles
Titles up to 8 characters long can be stored in
memory and displayed for CD and CD changer.
The number of titles that can be entered for
each mode are as follows.
1. Press the [SRC] button to select the mode
you want to enter a title (CD or CD changer).
2. Select and play a CD in the CD changer for
which you want to enter the title.
3. Press and hold the [DISP] button for 1
second or longer.
4. Press the [x] or [v] button to select
“TITLE IN”.
5. Press the [ ] button.
The display switches to the title input display.
6. Press the [x] or [v] button to move the
cursor.
7. Press the [BND] button to select a character
type. Each time you press the [BND] button,
the character type changes in the following
order:
Capital letters ➜ Numbers ➜ Symbols ➜
Umlaut ➜ Capital letters…
8. Press the [w] or [z] button to select the
desired character.
9. Repeat steps 6 to 8 to enter up to 8
characters for the title.
10.Press and hold the [ ] button for 2 seconds
or longer to store the title into memory.
Clearing titles
1. Select and play a CD in the CD changer for
which you want to clear the title.
2. Press and hold the [DISP] button for 1
second or longer.
3. Press the [x] or [v] button to select
“TITLE IN”.
4. Press the [ ] button.
The display switches to the title input display.
5. Press and hold the [BND] button for 1
second or longer.
All characters in the title disappear.
6. Press and hold the [ ] button for 2 seconds
or longer to store the setting.
AUX function
This system has an external input jack on the
front panel so you can listen to sounds and
music from external devices connected to this
unit.
● Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
∗ The factory default setting is “MID”.
1. Press and hold the [DISP] button for 1
second or longer.
2. Select “AUX SENS”.
3. Press the [w] or [z] button to select
“HIGH”, “MID” or “LOW”.
Note:
• When AUX mode is selected, AUX IN sensitivity
can be set.
Mode Number of titles
CD mode 50 titles
CD changer mode Number of titles
DCZ628 connected 100 titles