Basic Operations
English
15 DXZ388RUSB/DXZ389RUSB/DXZ389RGUSB
● Adjusting the treble
This adjustment can be performed only when
the Z-Enhancer Plus is set to “CUSTOM ”.
2-1. Select “TREBLE”.
3-1. Press the [w] or [z] button to select as
following order.
“TREB(G)” ↔ “TREB(F)”
∗ The factory default setting is “TREB(G)”.
3-2. Press the [ ] button.
3-3. Press the [w] or [z] button to select the
setting.
TREB(G) : The factory default setting is “0”.
(Adjustment range: +7 to
–7)
TREB(F) : The factory default setting is
“10K”.
(Adjustment range:
10K/12.5K/15K/17.5K)
3-4. Press the [ ] button to return to the
previous mode.
● Adjusting the balance
2-1. Select “BALANCE”.
3-1. Press the [w] or [z] button to adjust the
balance of the right and left speakers.
∗ The factory default setting is “CENTER”
(center). (Adjustment range: RIGHT12 to
LEFT12 (right 12 to left 12))
● Adjusting the fader
2-1. Select “FADER”.
3-1. Press the [w] or [z] button to adjust the
balance of the rear and front speakers.
∗ The factory default setting is “CENTER”
(center). (Adjustment range: FRONT12 to
REAR12 (front 12 to rear 12))
● Adjusting the subwoofer
You can set the low pass filter of subwoofer.
2-1. Select “S-W LPF”.
3-1. Press the [w] or [z] button to select as
following order.
“THROUGH” ↔ “LPF 50” ↔ “LPF 80” ↔
“LPF 120”
∗ The factory default setting is “THROUGH”.
● Adjusting the subwoofer output
volume
You can adjust the volume output from the unit's
subwoofer output terminal.
2-1. Select “S-W VOL”.
3-1. Press the [w] or [z] button to increases
or decreases the subwoofer volume.
∗ The factory default setting is “0”.
(Adjustment range: +6 to –6)
∗ When the volume level is more than 30, the
subwoofer volume adjustment value can not
reach +6.
● Adjusting the HPF
2-1. Select “HPF”.
3-1. Press the [w] or [z] button to select as
following order.
“120” ↔ “THROUGH”
∗ The factory default setting is “THROUGH”.
∗ This is supported only with amplifiers
equipped with this function. Output is not
supported from RCA cables.
Note:
• During SOUND adjustment mode, if no
operation is performed for more than 10
seconds, this mode can be cancelled and return
to previous mode.