Cisco Systems AIR-ANT1728 Stereo System User Manual


 
2
Cisco Aironet High Gain Omnidirectional Ceiling Mount Antenna (AIR-ANT1728)
78-14721-02
System Requirements
This antenna is designed for use with Cisco Aironet access points, but can be used with any 2.4-GHz
Cisco Aironet radio device that utilizes a RP-TNC connector.
Installation Notes
Choosing a Mounting Location
The location of the antenna is important. Objects such as metal columns, walls, etc. will reduce
efficiency. Best performance is achieved when transmit and receive antennas are mounted at the same
height and in a direct line of sight with no obstructions. If this is not possible and reception is poor, you
should try different mounting positions to optimize reception.
The antenna is designed to attach to and hang from a standard suspended ceiling track having a width
from 13/16 inches (20.6 millimeters) to 1 1/4 inches (31.7 millimeters).
Tools and Equipment Required
To install the antenna on a suspended ceiling track, you will need the following tools and equipment.
A ceiling track bracket (shipped with your antenna)
A 7/16 inch (11.1 millimeters) wrench
Cable ties or electrical tape
The following sections contain procedures for installing the antenna to a suspended ceiling track.
E-Plane Pattern H-Plane Pattern