Filter
Top Products
MCS-2 CONTROLLER
The left side of this controller is identical to the MCS-1 consult last page.
Page 6
8.) Reset
9.) Clear
10.) Clone RX
11.) Clone TX
12.) Clone/Learn LED
13.) OK LED
14.) Learn Button
15.) IR Sensor LED
16.) Numeric Entry
17.) Enter Button
18.) Macro Button
19.) Skip Backward
20.) Skip Forward
21.) Power On
22.) Reverse
23.) Forward
24.) Play
25.) Pause
26.) Stop
POWER
TAPE
DM2
AMFM
DM1
CD2
OK
CLONE/
LEARN
VOL
VOL
ERROR
IR SENSOR
LEARN
MUTE
CLONE TX
CLONE RX
PLAY
PWR
0
8
E
7
M
9
CD1
CLEAR
RESET
2
54
1
6
3
MCS-2
8.) Reset - This resets the local zone controller if an IR command locks up the zone. It will not erase the
local zone memory. It will just send a local clear command.
9.) Clear - This button has 3 modes: a.) Device mode - will clear learned commands from the local zone
memory. If you press clear and then say source selector #1 then the commands associated with that
page of memory will be erased. b.) Storage mode - this will allow any individual key to be erased and
reprogrammed. c.) Macro memory mode - this will allow you to reprogram a individual macro key (0 -9).
(This is a permanent erase function, so be careful with this command.)
10.) Clone RX - This button will place the controller into a ready to receive commands mode. This is the
learning mode. When setting up the system initially, place all but one controller in this mode and use the
one master controller to teach the local zones their commands. The clone/learn LED will light and stay
on. When the data is received correctly, the red LED will go out and the green OK light will go on. This
process takes between 6 and 8 minutes. *See detailed clone description on page 8.
11.) Clone TX - This button will place the controller into a ready to transmit commands mode. This is the
teaching mode. When setting up the system initially, place one controller in this mode and use it as a
master controller to teach the other local zones their commands. The clone/learn LED and OK LED will
stay on. When the data is transmitted correctly, the red LED will go out and the green OK light will flash
then go off. This process takes between 6 and 8 minutes. *See Page 8.
12.) Clone/Learn LED - This LED will let you know the status of transmit and receive during the learning
or teaching processes.
13.) OK - This LED will also let you know the progress of the learning/teaching processes. *See Page 8.
14) Learn Button - This button puts the controller into a learning mode.*See Page 8.
15.) IR Sensor - Use this IR window when teaching a controller new IR commands with an external
remote.