Filter
Top Products
connected. You may plug in the test plug while the unit is playing. You may hear a slight
click in the loudspeakers when inserting or removing the plug. This is normal.
SPEAKER: These switches change the 4 and 8 ohm output taps from the output
transformer to the speaker posts on the rear of the amplifier. They maybe operated
with the amplifier in operation.
EYE TUBE: There are two of these. They set the green eye tube intensity. You may set
to any desired level for your listening room. The control does not change any of the
sonic characteristics of the amplifier.
INSTALLATION
This section describes the unpacking and installation procedures for the Rocket 88 R
amplifier.
WARNING!
MAKE NO ATTEMPT TO PUT THE AMPLIFIER IN SERVICE WITHOUT
THE BOTTOM PLATE ATTACHED-CONTACT WITH VOLTAGE INSIDE
THE CHASSIS OF THE ROCKET 88 R CAN BE FATAL!
Unpacking
All shipping containers have been specifically designed to protect their contents and
special care has been taken to prevent damage under normal shipping conditions.
Mishandling should be evident upon inspection of the shipping container. If damage is
found after visual inspection, take care not to destroy the evidence. If necessary,
document the damage with photographs and contact the transport carrier immediately.
Carefully remove your new Rocket 88 R amplifier from its packing carton, and examine
it closely for signs of shipping damage. It is recommended to save all original packing
cartons to protect your amplifier from damage should you wish to store it or ship it for
after sales service.
Warranty Card
Fill out the enclosed warranty registration card and return it to Cary Audio Design
within 10 days of original purchase. Keep your original sales slip with the packing
cartons should you ever need it for reference. Failure to register warranty will limit the
warranty to one year.