Filter
Top Products
2
SPECIFICATIONS
Operating the CAD-211M amplifiers is a simple procedure since each unit is designed for
long term stability in virtually any home operating situation. Therefore, if the unit is
operated outside the parameters outlined in this owner’s manual, damage may result.
Please read this manual carefully before putting your new Cary Audio Design
CAD-211M mono block amplifier into operation.
The following definitions are applicable to this manual. These definitions must be
followed explicitly.
WARNING: ELECTRICAL HAZARD! MISUSE OR FAILURE TO FOLLOW
INSTRUCTIONS PROPERLY MAY RESULT IN PERSONAL
INJURY OR DEATH!
CAUTION: No risk of personal injury; however, misuse or failure to follow
instructions may result in damage of equipment.
NOTE: No risk of personal injury or equipment damage; however, misuse or
failure to follow instructions may prevent proper performance
of the equipment.
1.2
Specifications
The following section describes the CAD-211M basic specifications. Specifications are
subject to change without notice or obligation.
POWER OUTPUT: 80W
FEEDBACK: Zero
FREQUENCY
RESPONSE: 20Hz - 20KHz +
NOISE: 80dB Below Rated Output
SENSITIVITY: 2V
TUBE COMPLIMENT: 2 - 845 Output