Filter
Top Products
ON/OFF
DC IN
AUDIO
INPUT
POWER
SPEAKERS
L
–
+
R
–
+
BASS
LEVEL
12-14V 1.5A
S
OUND
W
ORKS
BY HENRY KLOSS
©CAMBRIDGE SOUNDWORKS
1-800-FOR-HIFI
12680
C
AMBRIDGE
S
OUND
W
ORKS
C
AMBRIDGE
S
OUND
W
ORKS
C
AMBRIDGE
S
OUND
W
ORKS
C
AMBRIDGE
S
OUND
W
ORKS
C
AMBRIDGE
S
OUND
W
ORKS
S
OUND
W
ORKS
TO
SUB
FROM
SOURCE
MIN
MAX
S
OUND
W
ORKS
TO
SUB
FROM
SOURCE
MIN
MAX
Satellite Speaker Cubes (2)
Subwoofer/Amplifier
Stands for Cubes (2)
12 Ft. Audio Connecting
Cable with Volume Control
and Mini-Plugs
12 Ft. Speaker Wires for
Connecting Cubes (2)
Semipermanent Mounting Strip
(1) for Attaching Volume Control
“Hook & Loop” Strip for Attaching
Cubes to Computer Monitor (4)
Wall-Mounting
Hardware for
Cubes (2)
Stick-On Feet
for Cubes or
Stands (2 Sets)
12-14 VDC External Power Supply
(12v Version Only)
2
Inspecting For Damage
Examine each speaker unit carefully
for shipping damage. If there is any,
do not install or use the system. For
advice, call the store where you
made your purchase.
All the items shown in the
illustration below should be
included with your system. If anything
is missing, contact the retailer where it
was purchased.
Save the carton and its inserts in
case you need to ship or move your
SoundWorks system later.
One of the first steps in setting up
SoundWorks is connecting the
small “cube” satellite speakers to
the subwoofer (see next page).
Therefore, before anything else,
prepare their connecting wires
as shown.
Getting Started
1
From both ends of each speaker cable,
pull off and discard the pre-cut strips of
insulation, revealing the bare wires.
Twist the individual strands of bared wire
tightly together so there are no free
strands that could short across the
speaker or amplifier terminals.
2
Note the red band around one wire at each
end of each speaker cable. This will help
you connect speakers “in phase” as
described on the next page.
3
Red
band
-