Filter
Top Products
The LK10 can only be used to control source equipment once it
has been cloned from the LR10. This transfers the necessary IR
codes and macros into the LK10. The Incognito LR10 is a
sophisticated learning remote which is able to learn the codes of
all the source equipment from their own remotes.
Once the LR10 itself has been programmed the user can clone all
macros and programmed information from the LR10 to the LK10,
allowing the keypad to also perform the same operations (IR
codes, macros, button names and clock settings).
Note: Only the learning buttons highlighted on the remote are
cloned to the LK10.
Please refer to the LR10’s own manual for full details on how to teach
codes into the LR10, advice on macros etc. Once the LR10 is fully
programmed/setup, you can clone it into the LK10.
To begin cloning, plug the supplied connection
cable into the cloning port on the LK10 and
LR10, then put the LK10 into Learn mode.
Set the LR10 to transmit (the LK1O will default
to Receiving mode).
On the back of the LR10 press the Edit button
4 times (using a paperclip or similar) to enter
Clone mode. ‘REC/TRX’ will appear on both
displays.
10
Cloning from the remote control
(Set) Menu Title Exit
Fav-1Shift
EDIT SLEEP LEARN
SHARED
PM