Filter
Top Products
5
LOADING AND UNLOADING DISCS
1. Press the POWER switch.
2. Press the OPEN/CLOSE button. The disc tray will open. If the disc tray
is blocked while operating, the tray will stop and automatically after
approximately 8 seconds.
3. When the disc tray has opened fully, place a disc carefully in the tray
with the label side facing up.
4. To close the disc tray, press the OPEN/CLOSE button again. When
the tray with a correctly loaded disc is fully closed, the disc will start
turning automatically. After the CD player has read the disc it will be
in standby mode, the display looking like the example below - here there
are eight tracks on the disc, which have a total running time of forty
eight minutes and fifty five seconds
.
5. The disc tray can be opened at any time by pressing the OPEN/CLOSE
button. Only remove the disc after the tray has fully opened
NOTE
Do not put anything except a Compact Disc into the tray, foreign objects
may damage the mechanism.
Do not force the tray by hand during the opening and closing operations.
To avoid dirt and dust entering the mechanism, keep the disc tray closed.
If the Compact Disc is seriously scratched or too dirty the player may not
be able to read it or play it.
Never load more than one disc into the disc tray at one time.
FRONT PANEL CONTROLS
Refer to the diagram on your accompanying Owner’s Manual
1. POWER
This control switches the mains power to the Compact Disc player ON
and OFF.
2. OPEN/CLOSE
Allows you to open and close the disc tray, thus making it possible to
load a disc
3. PROGRAM/REPEAT
Allows the program and repeat functions to be accessed
4. RANDOM
Allows the player to choose the order in which the tracks are played
5. STOP
Stops the CD playing
6. PLAY/PAUSE
Plays the disc and pauses play
7. SHUTTLE SWITCH
Skips between tracks and searches through tracks
IMPORTANT NOTE
This unit has been designed to
play Compact Discs bearing the
identification logo shown here. No
other discs can be used
OPERATION