Cambridge Audio D-Series CD Player User Manual


 
3
E
GREEN /
YELLOW
BLUE
FUSE
BROWN
CORD
GRIP
N
L
SAFETY PRECAUTIONS
CHECKING THE POWER SUPPLY SETTING
For your own safety please read the following instructions carefully
before attempting to connect this unit to the mains.
Check that the rear of your unit indicates the correct supply voltage.
If your mains supply voltage is different, consult your dealer.
This unit is designed to operate only on the supply voltage and type that
is indicated on the rear panel of the unit. Connecting to other power
sources may damage the unit.
SAFETY PRECAUTIONS
This equipment must be switched off when not in use and must not be used
unless correctly earthed. To reduce the risk of electric shock, do not
remove the unit’s cover (or back). There are no user serviceable parts
inside. Refer servicing to qualified service personnel. If the power cord
is fitted with a moulded mains plug the unit must not be used if the plastic
fuse carrier is not in place. Should you lose the fuse carrier the correct
part must be reordered from your Cambridge Audio dealer.
The lightning flash with the arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence
of uninsulated ‘dangerous voltage’ within the product’s
enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance instructions in the service literature relevant
to this appliance.
This product complies with European Low Voltage
(73/23/EEC) and Electromagnetic Compatibility
(89/336/EEC) Directives when used according to this
instruction manual. For continued compliance only
Cambridge Audio accessories should be used with
this product and servicing must be referred to qualified
service personnel
PLUG FITTING INSTRUCTIONS (UK ONLY)
The cord supplied with this appliance is factory fitted with a 13A mains
plug fitted with a 3A fuse inside. If it is necessary to change the fuse, it
is important that a 3A one is used. If the plug needs to be changed because
it is not suitable for your socket, or becomes damaged, it should be cut off
and an appropriate plug fitted following the wiring instructions below. The
plug must then be disposed of safely, as insertion into a 13A socket is likely
to cause an electrical hazard. Should it be necessary to fit a 3-pin BS mains
plug to the power cord the wires should be fitted as shown in this diagram.
The colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug. Connect them as follows:-
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter ‘N’ or coloured BLACK.
The wire which is coloured BROWN must
be connected to the terminal which is
marked with the letter ‘L’ or coloured RED
The wire which is coloured GREEN/
YELLOW must be connected to the terminal
which is marked with the letter ‘E’ or
coloured GREEN.
NOTE: If your model does not have an earth wire, then disregard this
instruction.
If a 13 Amp (BS 1363) plug is used, a 3 Amp fuse must be fitted, or if any
other type of plug is used a 3 Amp or 5 Amp fuse must be fitted, either
in the plug or adaptor, or on the distribution board.