840C Upsampling compact disc player
Azur upsampling compact disc player 11
Amp Control mode
The 840A/C remote control comes with an Amplifier Control
button, that when pressed, puts the remote into Amp mode,
allowing operation of a Cambridge Audio Azur amplifier. When
pressed, the LED will light up for 7 seconds (to let you know you
are in Amp mode), and will then flash when any of the relevant
circled Amp buttons is pressed. All other remote buttons are
inactive when in Amp mode.
The functions relevant to the amplifier are as follows:
Standby/On
Switches the amplifier between On and Standby mode.
Numerical buttons 1-8
Press to change the input source to the amplifier. Button 8 toggles Tape
Monitor on/off.
Mode
Press to switch between Volume and Balance modes.
Mute
Mutes the audio on the amplifier. The mute mode is indicated by MUTE
appearing and the volume level being replaced by two flashing dashes
in the display. Press again to cancel mute.
Volume
Increase or decrease the volume of the amplifier output.
Speaker A/B
Press to scroll through the speaker sets connected to the loudspeaker
terminals on the back panel (speaker sets A, B or A and B).
Bright
Adjust the backlight of the front panel display; bright, dim or off.
To exit Amp mode (and return to CD mode), press the Amp Control
button again (the LED will light up for one second).
Mode
Speaker
A/B
REMOTE CONTROL OF MATCHING PRODUCTS