Filter
Top Products
16 Azur integrated amplifier
There
is
no
power
Ensure the AC power cord is connected securely.
Ensure the plug is fully inserted into the wall socket and is switched on.
Check fuse in the mains plug or adaptor.
There
is
no
sound
Make sure the unit is not in Standby mode.
Check that source component is properly connected.
Check that 'TAPE MON' is not switched on (unless tape input is required).
Check that your speakers are properly connected.
If using Speaker B terminals check they are switched on.
If channel LED is flashing turn mute off.
There
is
no
sound
on
one
channel
Ensure that balance control is in the correct position.
Check speaker connections.
Check interconnects.
TROUBLESHOOTING
There
is
a
loud
buzz
or
hum
Check turntable or tone arm for ground and connection lead fault.
Ensure no interconnects are loose or defective.
Ensure that your tape deck/turntable is not too close to the amplifier.
Unable
to
make
or
play
tape
recordings
Check that TAPE MON and TAPE OUT have been connected correctly.
There
is
weak
bass
or
diffused
stereo
imaging
Ensure that speakers are not wired out of phase.
Protection
LED flashing
See section on CAP5 protection system.