Filter
Top Products
9
Stand Removal
and Installation
Satellites on Flat
Surfaces
Mounting Satellites on Walls
Mount satellites only on walls that are structurally sound.
Position front satellites at or slightly below ear level.
Position rear satellites to the sides and a little above ear level.
Before placing the satellites on a flat
surface, apply the rubber pads to the
bottom of the satellite.
Unscrew the thumbscrew to release
the satellite from the Desktop Stand.
Reverse the process to install a
Centre Stand.
1
Drill a hole about
2 cm (1 inch) deep
into wall.
2
Tap plastic anchor
into hole until it is
flush with wall.
3
Screw a M5 x 25 mm screw
into anchor, leaving about
0.5 cm (¼ inch) protruding.
5
Slip keyhole slot of each rear
satellite onto protruding
screw.
4
Apply rubber pads
on the back of each
rear satellite.