Filter
Top Products
14 3
Service and Repair Instructions
In the event that service should become necessary for any reason, contact the dealer from whom you
purchased this unit. The service or repairs can be done promptly and efficiently by your Califone dealer. If
you wish assistance from the factory, write us:
Attention: Customer Service
Califone International Inc.
21300 Superior Street
Chatsworth, CA 91311
Or, call, toll free: (800) 722-0500
Be sure to have the model and serial number available. Please DO NOT SHIP ANY UNIT TO THE
FACTORY WITHOUT PRIOR AUTHORIZATION AND INSTRUCTIONS.
Specifications
Output Power 6W
Radio Frequency Range AM 525-1710KHZ
FM 88 – 108 MHz
Cassette Frequency Resp. 80Hz – 12000Hz
CD Frequency Response 20Hz – 20000Hz
Power Supply AC 110V – 60Hz, 8”D” (UM-1) Cells
Dimensions (WxHxD) 16 1/4”W x 6 1/4”H x 9 1/4”D
Weight 7 lbs.
Troubleshooting
PROBLEMS ITEMS TO CHECK
General
The unit does not operate. Is the AC power cord unplugged?
Are the batteries fully charged?
Cassette
Cassette cannot be loaded. Is cassette being loaded properly?
Is the PLAY key depressed?
The tape does not move. Is the PAUSE key depressed?
The tape gets caught in the tape Is the pinch roller or capstan dirty?
transport mechanism. Is there excessive slack in the tape?
Tape speed is slow. Is the tape too old or the quality bad?
Inspecting & Unpacking
Although the shipping carton and packaging materials are designed to prevent damage during shipment, you
should inspect the carton for any signs of mishandling or damage immediately upon receiving your new unit.
Carefully lift the unit from the carton and inspect it for any signs of damage. Save all packaging materials for
possible later use.
Note: Any shipping damage or loss claims must be submitted to the freight agent.
Your carton and packaging should contain the following:
• 2385AV-02 CD/Cassette/AM/FM Radio OR
• 2395AV-02 CD/Dual Cassette/AM/FM Radio
• Owner’s Manual
• Califone Warranty Registration Mail-In Card
• Project Intercept Tag
Initial Set-Up
AC Line Operation
1. The power cord is located at the rear of the unit. Release the cord retainer tab and uncoil the cord.
2. Plug the cord into a standard 120 volt 50-60 Hz AC outlet. Be sure the plug blades are fully inserted. THE
UNIT IS ON WHEN PLUGGED IN.
Battery Operation
1. The battery compartment is located at the rear of the unit. Push the lever at the center of the door toward
the rear of the unit, then lift the door free.
2. Eight “D” or UM-1 size batteries are required. When installing refer to the orientation diagram shown
inside the battery compartment. Place the batteries on top of the nylon ribbon. This helps to “pop” old
batteries out when you need to replace them.
3. Replace the battery cover.
IMPORTANT: Remove all batteries from your cassette unit if it will not be used for an extended period of time.
DO NOT LEAVE DISCHARGED BATTERIES IN THE BATTERY COMPARTMENT. DAMAGE TO THE UNIT DUE TO
BATTERY CORROSION IS NOT COVERED UNDER WARRANTY.
NOTE: Califone cassette recorders are designed for use only with Type 1 Normal Bias
recording tape.