Filter
Top Products
D. INSTALLATION
1. TRANSMITTER
A. Connect the supplied AC power adapter to an electrical wall outlet.
B. Plug the AC power adapter in the DC jack located on the rear of the transmitter.
C. Or you can insert 4 X “AA” size ALKALINE batteries into the battery compartment at the bottom of the
transmitter with correct polarity.
D. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, i-pod,
DVD, and CD/MP3 players or to headphone/earphone jack with the connector provided.
Turn the switch to On and the LED of transmitter will light up in Green. When the audio cable has been
connected turn on the audio source to at least the mid range level and play the music. The LED will turn from
Green to Blue (note: if the audio source is not in the play mode the LED will not turn from green to blue). If a
speaker is not turned on within 4 minutes the transmitter light will turn from Blue back to green to save power.
2. SPEAKER
A. Insert 6 x AA size ALKALINE batteries into the battery compartment with correct polarity at the bottom of
the speaker.
B. Tighten the battery door clockwise and make sure it is closed firmly without any gap.
C. Press the Power button to turn the speaker ON. The Power LED will light up in Green. When the signal
link is established between the transmitter and speaker, the LED on the speaker will change to Blue.
Battery Compartment