Filter
Top Products
CCRadio2 Page 9
Getting Started
Please read this entire section carefully before you start. Set the
time with the radio off. You must go through the steps listed below
without stopping for more than 15 seconds at any given time or you will
have to start over. (Refer to page 5 for Button Identification.)
1) Press the Clock Set Button. The hour digit will flash.
2) Using the Up/Down Tuning Button, select the appropriate
hour digit and AM or PM.
3) Press the Clock Set Button again to select the minutes digits, the
minutes digits will flash. Use the Up/Down Buttons to adjust the
minutes to the appropriate time.
4) You must press the Clock Set Button again to complete the time
setting. This also sets the seconds to “00”.
There are two different alarm modes on the CCRadio2. You can choose
to wake up to the radio or to a tone. You can set the alarm with the
radio on or off. If the radio is off, the beep volume is significantly reduced.
To set the type of alarm:
Press and hold the Alarm Button until you hear a
beep and see one of these symbols flashing on
the display.
To wake with the radio: While Alarm is flashing on
the display, press the Clock Set Button until you see the symbol shown
to the right. When the alarm goes off the radio will play the last station
selected at the same volume level last set.
To wake with a multi level tone: While Alarm is flashing,
press the Clock Set Button until you see the symbol shown to the right.
To shut off the alarm function: Press and hold the Alarm Button until
you hear a short beep and the alarm symbol disappears.
To set the alarm time:
1) Press and hold the Alarm Button, the hour digit and Alarm
symbol will flash.
2) Using the Up/Down Tuning Button, select the appropriate
hour.
3) Press the Alarm Button again. Use the Up/Down Tuning Buttons
to adjust the minute to the appropriate time.
4) Press the Alarm Button again to complete the alarm setting.
SETTING THE CLOCK
SETTING THE ALARM