Bryston 6B SST Stereo Amplifier User Manual


 
6BSST THREE CHANNEL POWER AMPLIFIER
6
Rack Mounting Instructions
Removing the channels makes rack
mounting far easier as the chassis will
be much lighter.
Before removing any screws from
the 6BSST be sure the power cord is
removed from the unit.
Remove the screws indicated on the
top and bottom views plus the ones
described on the sides.
Pull gently on the channel handle to
remove the channel. Be prepared to use
both hands to handle the channel.
It should not be necessary to remove
the power input module.
Install 6BSST chassis in rack.
Carefully reinstall the channels.
REMOVE ALL 6-32 SCREWS ON
THE BOTTOM.
The removal of the feet should not
be necessary as clearance below the
amplifier MUST be at least 1U
when rack mounting.
REMOVE 4
6-32 SCREWS
FROM THIS
SIDE
REMOVE 3
3-32 SCREWS
FROM THIS SIDE
The 6BSST 19” version may be rack mounted with or without the ability to remove the channels. If removal of the chan-
nels is desired then the shipping screws securing the channels need to be removed.
FUSES - USE SAME TYPE ONLY
FAST ACTING 4A 250V 5mm X 20mm
TOP VIEW
BOTTOM VIEW
REMOVE 8 SCREWS 632 X 3/8”
DO NOT REMOVE
SCREWS FROM
RACK MOUNT
BRACKET
DO NOT REMOVE SCREWS FROM
RACK MOUNT BRACKET