Filter
Top Products
Page 6
Voltage Trigger
The BA-200 is capable of being triggered to turn on using the input labeled Control. The BA-200 is designed to respond to any incoming voltage of3-30
volts. Many audio components have a voltage output for this purpose. The connection is easily made using a mono cable with a 3.5 mm mini connection on
both ends. A voltage trigger cable is supplied with the package. This is plugged into the voltage trigger output on the source component and into the voltage
input on the BA-200. The BreatheAudio Elevate Audio Distribution System has an output labeled Control for use with the BA-200, fig. 3. By using the voltage
trigger, the BA-200 power switch can be left in the on position and triggered to turn on and off automatically by the presence of a voltage from the audio
source equipment.
CONTROL
AUDIO
OUTPUTPOWER
SPEAKER
INPUT
8OHM: 70WX2
4OHM:100WX2
LEFT
RIGHT
-
-
+
+
USE ONLY WITH 250V FUSEUSEONLY WITH 250V FUSE
3033118
C
US
I
N
T
E
R
T
E
K
C
M
CONFORMS
TO
ULSTD.
3033118
C
US
I
N
T
E
R
T
E
K
C
M
IR OUT OUTPUT
CONTROL
AUDIO
1
2
USEFOR SAT
ORCABLE
56KHz
www.breatheaudio.com Cincinnati OhioUSA
FUSE:T2AL250V
120V 60Hz 150W
38KHz
NORMAL
USE
THIS DEVICECOMPLIES WITH PART 15OF THEFCCRULES.
OPERATIONIS SUBJECTED TOFOLLOWING TWO CONDITIONS:
(1) THISDEVICE MAYNOT CAUSE HARMFULINTERFERENCE,AND
(2) THISDEVICE MUSTACCEPT ANYINTERFERENCE RECEIVED,
INCLUDING INTERFERENCETHAT MAY CAUSEUNDESIRED OPERATION.
WARNING:TOREDUCETHERISK
OFFIREORELECTRICSHOCK.
MODELBA-2430
TwoSource FourZone
WholeHome MusicSystem
Fig. 3
Speaker Output
The BA-200 provides 100 watts output per channel at 4 ohms and is stable down to 2 ohms. This allows it to provide an audio signal to multiple pairs of
speakers in a large area. It uses a modular plug that will accept up to 14-gauge, two or four-conductor speaker wire, however 16-gauge wire is
recommended. The proper polarity is Left negative, Left positive, Right negative, and Right positive, fig. 4.
-
-
+
+
LEFT
RIGHT
LEFT
RIGHT
Fig. 4