Filter
Top Products
Tuning - Front / Rear Speakers
9
Tuning The Amplifier - Front or Rear Speakers
6) Input Sensitivity Control
Slowly rotate the control clockwise (refer to the diagram on page 5) until maximum undistorted playing level is
heard from the speakers. Listen closely for bottoming from the speakers. If detected, rotate the input sensitivity
control counterclockwise until it is eliminated.
7) Crossover Controls
To achieve higher undistorted playing levels from the main speakers, the highpass crossover must be engaged.
R
otate the crossover control fully clockwise (refer to the diagram on page 5). The highpass crossover point is now
set at 350Hz. Rotate “Q-Tune
™
” Control fully counterclockwise. Move crossover switch to the right (ON) position.
Slowly rotate the input sensitivity control clockwise until maximum undistorted playing level is heard from the
speakers. Listen closely for bottoming from the speakers. If detected, rotate the input sensitivity control counterclock-
wise until it is eliminated. Slowly rotate the highpass crossover control counterclockwise while listening for
bottoming. You are lowering the crossover point, which means that more bass signal is being sent to the speakers. If
bottoming is detected, rotate the input sensitivity control counterclockwise until it is eliminated and/or rotate the
Highpass crossover control clockwise to raise the crossover point.
8) Q-Tune
™
Control
Once the highpass crossover point has been determined, use the Q-Tune
™
control (refer to the diagram on page 5)
to increase the bass information centered around the crossover point.
Setting the Q-Tune
™
control is done in conjunction with setting the levels on the input sensitivity and highpass
crossover frequency controls. You may find while setting the Q-Tune
™
that over-excursion may be detected in the
front speakers; lowering the Q-Tune
™
input sensitivity or raising the highpass crossover point will eliminate this.
Minor adjustments to each setting are required to fine-tune the system.
Setting the Q-Tune
™
is a subtle process. It is recommended that the Q-Tune
™
setting be left in the 0.7 position and
adjusted only after the input sensitivity and highpass crossover ranges are known. Small adjustments to the Q-Tune
™
setting are all that are required to fine-tune the system.
fuse
2-Channel Operation Wiring Configuration Diagram