Filter
Top Products
Wood Shims
Installation (Cont.)
7) If you plan to attach the Sub10F directly to the joists using screws, use wood shims to prevent dam-
age to the Sub10F enclosure. It is important to use wood shims so that there are no gaps between the
sides of the Sub10F and the joists. Remember to drill pilot holes. See diagram below.
8) Attach the speaker wire securely to the terminals on the end of the Sub10F.
9) Install the floor register. For installations on hardwood floors, a foam gasket may need to be placed
under the floor register.
Specifications
SA1 Power Amplifier Sub10F
Frequency Response (±3dB) — 29–160Hz (with SA1)
Recommended Amplifier Power — Must use with SA1 amplifier
Nominal Impedance 8 Ohms
Bass Unit — 10" DCD
TM
copolymer
Amplifier Power < 1% THD 140 watts continuous, 8 ohms —
210 watts continuous, 4 ohms
Crossover Frequency 40–160Hz 40-160Hz (on SA1)
24dB/Octave Lowpass
Inputs L&R stereo RCA line level —
& LFE RCA line level for
crossover bypass
12-volt Trigger Input Voltage 9–14 volts DC @ 1.5mA —
max.
1
/8" diameter female
plug with tip positive
External Dimensions 3
1
/2 x 19 x 12
1
/2" (89 x 483 x 318mm) 14
1
/16 x 31
1
/2" (357 x 800.1mm)
[H x W x D w/o feet]
3
5
/8 x 19 x 12
1
/2" (92 x 483 x 318mm)
[H x W x D w/feet]
2 EIA rack space w/feet removed
Mounting Depth (from surface) — 8
1
/4" (209.55mm)
9
1
/4" including 1” gasket
5