Filter
Top Products
BV7300 User’s Manual - page 10
Adjusting the Volume Level
Press VOL+/- to adjust the volume level.
Last position memory
- During disc, USB or SD/MMC card play-
back, press and hold the to turn off the
unit, when you next turn on the unit, the
DVD unit will resume playing from the point
that it was interrupted.
- During disc, USB or SD/MMC card play-
back, if you press MODE to switch to a dif-
ferent mode, when you next return to DVD
mode, playback will resume from the point
at which it was interrupted.
Radio operation
VOLUME 25 AM 07:12
FM1 STEREO LOC
RADIO
107.15 MHZ 2
Selecting the frequency band
Press BAND button repeatedly to select
the desired radio band.
Stereo/Mono
FM listening is generally done in Stereo
mode. However, if the signal is weak or
reception is not as good as you would like,
switching to Mono mode usually improves
the overall sound quality. To switch to Mono
mode, press ST (or MO•ST on the remote
control). Press it again to return to Stereo
mode.
Local/Distant
In urban settings, most stations are strong
enough to listening in LOCAL mode.
However, if a station seems too distant to
be received well, try switching to DISTANT
mode by pressing and holding ST/LOC
(or pressing LOC on the remote control).
Press it again to return to LOCAL mode.
Selecting Stations
- Press preset station button 1-6 to select
a station which has been stored in the
memory.
- Press and hold the or buttons until
“MANUAL” appears on the screen, then
press or buttons to select a station.
If both buttons have not been pressed
for several seconds, the unit will return to
automatic seek mode.
Automatic Memory Storage & Program
Scanning
- Automatic Memory Storing
This feature is used to automatically set up
presets for the radio. Press and hold the
AS•PS to start the tuner searching the fre-
quency band and storing the six strongest
stations as presets.
- Program Scanning
After the presets have been recorded,
when you press this button, the radio will
scan the preset buttons in order. It will play
a station for a few seconds, and then move
to the next. When you hear a station that
you wish to listen to, press the AS
•PS but-
ton again to stop the scanning.
Setting up Presets Manually
To set up the presets manually, tune to the
desired station using the and buttons.
When you fi nd a station you like, press and
hold the desired preset button for a few
seconds to store it.