9
EXPERIENCE THE SOUND
English Deutsch FrançaisDansk Español Italiano SvenskaNederlands
To remove an insert from the dock
1. With your thumbs on the front of the dock near the Bose
®
logo, and your index fingers inside it,
pinch until the rear of the insert lifts up (
Figure 8).
2. Lift out the insert and replace it with the one you need.
Figure 8
Removing an
insert
Troubleshooting
Problem What to do
Your iPod does not dock
properly
• Make sure the dock insert is the proper fit for your iPod
(refer to “Using the correct insert” on page 5).
• Remove your iPod from the dock and check for obstructions on the connectors
in the dock and on your iPod. Then reseat it in the dock.
No sound • Make sure the system is plugged in, your iPod is turned on, and a music track is
selected and playing.
• Press the Play/Pause button on the remote control.
• Increase the volume setting for the system.
• Remove your iPod from the dock, wait briefly, then reseat it. You may need to do
this a few times.
• Make sure your iPod is running compatible software
(refer to “To check for iPod compatibility” on page 6).
No sound and your iPod
is not charging
• Make sure the power cable is securely plugged into a functioning wall outlet and
the symbol on the small connector is matched to the one on the back of the
SoundDock
TM
system. Refer to Figure 4 on page 6.
• Make sure your iPod is firmly seated in the dock.