Filter
Top Products
6
YOUR SL2 WIRELESS SURROUND LINK
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands
Making the connections
Use the small power pack with the SL2 transmitter (Figure 3). The large power pack is for use
with the SL2 receiver.
Figure 3
Different power
supplies
Transmitter
power pack
Receiver
power pack
SL2 transmitter
SL2
rece
i
ver
Input jack
Output jacks
AC power jack
AC power jack
Before you plug either of the supplied power packs into the wall, make all the other
connections.
Connecting the SL2 transmitter
Use the supplied transmitter cable to connect the SL2 transmitter to your Acoustimass
®
module,
as follows (Figure 4):
1. Insert the single connector at one end of the cable into the input jack labeled
Acoustimass
Module on the back of the SL2 transmitter.
2. Connect the other end of the transmitter cable to jacks on the Acoustimass module.
• Insert the purple connector marked RR into the jack labeled Right Rear or Surround R.
• Insert the green connector marked LR into the jack labeled Left Rear or Surround L.
3. Connect the cable end of the transmitter power pack to the small jack labeled DC Power
on the back of the SL2 transmitter.
4. Plug the transmitter power pack into a nearby AC mains outlet.
Figure 4
Transmitter
connections
Transmitter
cable
SL2 transmitter
Transmitter
power
pack
(120V
shown)
Acoustimass module
Surround
speaker jacks
Status LED
When the power supply is plugged in, a Status LED on the back of the transmitter blinks
green until it links to the receiver. It then lights a solid orange until there is an audio signal to
transmit.
02_Introduction.fm Page 6 Monday, August 7, 2006 9:53 AM