Filter
Top Products
9
SETUP
English Deutsch FrançaisDansk Español Italiano SvenskaNederlands
To control volume when a non-Bose product is the sound source:
• There is no need for an expansion room remote control.
• Use the remote that came with the tuner/receiver in the room where it is connected to the
transmitter.
• Use the volume control on the system, radio, or powered speakers connected to the
receiver in the other room.
To control non-Bose or older Bose
®
products in the expansion room:
• Use a Bose
®
link remote control or the PERSONAL
®
music center II to select audio from the
LIFESTYLE
®
system in the main room.
• Use the product remote or console control for local volume adjustments.
Check the indicators and settings
Before you use the audio link, you may want to check some of the indicators and settings
that make your expansion products work together smoothly.
The Status LED
On the connection panel of both the transmitter and the receiver, the Status LED indicates
how the two units are communicating, as shown in the table below.
Status LED Blinking green Solid green Blinking orange Solid orange
On the
transmitter
Searching for
receiver
Receiver
located
Not
applicable
Powered on,
no communication
On the
receiver
Searching for
transmitter
Solid signal
received
Weak signal
received
Weak or no signal
received
On the receiver, a blinking or solid orange light indicates a communications problem. Reposi-
tioning the transmitter, receiver, or both, may resolve the problem and cause both LEDs to
change to solid green. For further information, refer to “Troubleshooting” on page 11.
The transmitter Channel button
You can use the Channel button to narrow the selection of frequencies the transmitter uses.
The transmitter is factory-set to avoid WiFi Channel 11. This helps prevent performance
problems, such as slow or intermittent data transmissions, on a wireless network. If you have
a wireless network set up on another channel, you can set up your transmitter to avoid that
channel, or you can move the WiFi network to Channel 11.