Filter
Top Products
12
S
YSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands DanskItalianoSvenska DeutschNederlands EnglishFrançais Español
Adding a T1 ToneMatch
TM
audio engine (optional)
The T1 ToneMatch
TM
audio engine provides additional input/output capabilities to your
system, plus digital signal processing to customize the way you sound. The audio engine
comes with hardware for mounting it on the left or right side of the L1
TM
model II Cylindrical
Radiator
®
loudspeaker.
Note: The audio engine mounts on the bottom section of the loudspeaker and requires removal
of the top section before starting this procedure.
1. Slide the carriage into the channel on the rear of the L1 bottom and turn the knob
clockwise to lock it in place (Figure 8).
2. Insert the mounting bar into the slot in the carriage and push it downward.
3. Place the T1 on the mounting bar as shown.
4. Plug one end of the ToneMatch cable (supplied with the audio engine) into the
ToneMatch output port ( ) on the T1.
5. Using the hook and loop strap, secure the cable to the carriage.
6. Plug the other end of the cable into the ToneMatch port on the power stand.
Figure 8
Mounting the T1
4
5
6
Carriage
Mounting bar
L1 model II Cylindrical
Radiator
®
loudspeaker bottom
T1 ToneMatch
audio engine
1
2
3
Locking knob
Power stand
Hook and loop strap
T1 ToneMatch
audio engine
L1 model II
Cylindrical
Radiator
®
bottom
ToneMatch cable
(supplied with T1)
VeniceOG.book Page 12 Tuesday, January 16, 2007 1:28 PM