Filter
Top Products
12 October 22, 2001 AM19464_02_V.pdf
English
Setting Up
Check the connections
Check all connections from the receiver to the Acoustimass
®
module and the module to the
cube speakers (Figure 9). Make sure all speakers are connected to the proper terminals
according to their position in your room.
At the receiver, check that the wires are connected in phase (+ to + and – to –). Incorrect
wiring can result in a total loss of Acoustimass module output.
Be sure to correct any wiring problems before you plug your receiver in and turn it on.
CAUTION:
Do not allow exposed wires to brush against each other; this could damage
your receiver.
Figure 9
Completed connections
SURROUND SPEAKERS
R CENTER
FRONT SPEAKERS
R
L
LREAR
INPUTS
LEFT CENTER RIGHT LEFT RIGHT
SURROUND SURROUND
TO CUBE SPEAKERS
LCRLSRS
OUTPUTS
FROM RECEIVER OR AMPLIFIER
LCRLSRS
RCL
RS LS
Attach the module end cover, if desired
The module end cover is designed to hide the cabling and extend the smooth, clean lines of
the Acoustimass module. However, because the cover has a beveled surface, you cannot
stand the module on that end with the cover in place.
If you plan to use the cover, attach it to the cable end after all connections have been
checked (Figure 9). Gently push the end cover into the grommets on the Acoustimass
module (Figure 10).
Your set-up is complete. Enjoy your Acoustimass 10 Series II speaker system.
Figure 10
The module end cover fits over
the cables