Filter
Top Products
10 December 20, 2001 AM183644_01_V.pdf
Setting Up
Check the connections
Check all connections from the receiver to the Acoustimass
®
module and the module to the
cube speakers (Figure 9). Make sure all speakers are connected to the proper terminals
according to their position in your room. Also make sure the two speakers with black
terminal tabs are connected as front speakers.
At the receiver, check that the wires are connected in phase (+ to + and – to –). Incorrect
wiring can result in a total loss of Acoustimass module output.
Be sure to correct any wiring problems before you plug your receiver in and turn it on.
Figure 9
Completed connections
LEFT CENTER RIGHT LEFT RIGHT
SURROUND SURROUND
FROM RECEIVER OR AMPLIFIER
LCRLSRS
INPUTS
LCR
LS RS
TO CUBE SPEAKERS
LCRLSRS
OUTPUTS
SURROUND SPEAKERS
L REAR R CENTER
FRONT SPEAKERS
R
L
CAUTION:
Do not allow exposed wires to
brush against each other; this
could damage your receiver.