Filter
Top Products
10
INSTALLATION
EnglishTAB 6TAB 8 TAB 7 TAB 3TAB 5 TAB 2TAB 4
Testing each speaker
With the speakers secured to your ceiling, you can
make sure the speaker functions properly before you
attach the grille.
CAUTION: Before you turn on your receiver/amplifier,
be sure there is no unused speaker cable connected to it.
An attached cable that is free at one end can cause a
short and damage your receiver/amplifier.
1. Turn on the receiver/amplifier and play a piece of
music that is familiar to you.
2. Make sure the sound is clear and free of static.
Static may indicate that the speaker cable is not
connected properly. Refer to the “CAUTION :” on
page 8.
Note: To remove the speaker and check the connections,
loosen two of the screws that are opposite each other
first. Use one hand to support the speaker as you loosen
the third screw. Continue to support the speaker and
carefully loosen the final screw.
Attaching the grille
The grille is designed to fit into the slots on the rim of
the speaker and lock into place with a slight clockwise
twist.
1. Notice the six snaps along the inside edge of the
speaker grille.
2. Position these snaps below the six slots along the
rim of the speaker.
3. On the rim of the speaker, notice the six slots that
the snaps fit into.
4. Press the grille onto the rim of the speaker until you
feel the snaps engage and twist the grille slightly to
lock the snaps securely.
Note: If you find it difficult to twist the grille, use rubber
gloves or place a piece of non-slip material over the grille
to improve your grip.
5. Rotate the Bose
logo, as needed, to adjust it for
your room layout.
Snap
Slot
Bose
®
logo
04_Installation.fm Page 10 Friday, June 12, 2009 11:34 AM