Filter
Top Products
Bosch Diagnostics 1 689 989 001 2007-05-30|
Operation | KTS 200 | 23 | 23
5. Operation
5.1 Connection to the vehicle
The KTS 200 is designed for operation on a vehicle
with a battery voltage of 12 Volts and 24 Volts.
Make sure that the OBD diagnostic lead is correctly
plugged into the KTS 200 and securely screwed
in. If incorrectly plugged in, the pins on the male
connector may bend or be broken off. Only use the
OBD diagnostic lead supplied.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
3
5
2
U
SB
15VD
C
KTS 20
0
Pow
e
red by ESI[
tronic]
B
O
S
C
H
459804/3Ko
4
6
7
Fig. 3: KTS 200 connection schematic
1 OBD diagnostic socket in vehicle
2 OBD diagnostic lead
3 UNI connecting lead (special accessory)
4 KTS 200
5 Power pack
6 Connecting lead for cigarette lighter socket
7 USB connecting lead
When placing the KTS 200 on the steering
wheel, there is a risk of injury due to
triggering of the airbag.
The connection to the diagnostic interface in the
vehicle is made via
the OBD diagnostic lead (Fig. 3, item 2) or
the OBD diagnostic lead and also the UNI connecting
lead (Fig. 3, item 3; special accessory) or
the OBD diagnostic lead and a vehicle-specific
adapter lead (special accessory) or
a vehicle-specific adapter lead (special accessory).
5.2 Turning on
The KTS 200 is normally supplied with power by the
OBD diagnostic socket in the vehicle. If the position of
the OBD diagnostic socket in the vehicle is not known,
we recommend connecting the KTS 200 to the cigarette
lighter socket using the connecting lead and searching
for the OBD diagnostic socket using the KTS 200
control unit diagnosis software.
On some vehicles, the cigarette lighter socket only
supplies power when the ignition is turned on.
In test steps that require the engine to be started,
the battery voltage may drop to a point at which the
supply from the vehicle is no longer guaranteed. In
these cases, it may be necessary to use the power
pack to supply the KTS 200 with power.
On some vehicles, the power supply may only be
present on the OBD interface when the ignition has
been turned on.
If the KTS 200 is connected to a PC/laptop using the
USB connecting lead, the KTS 200 power supply must
come from the power pack supplied.
5.3 Turning off
The KTS 200 is always turned off when the OBD
diagnostic lead, the power pack or the connecting lead
for the cigarette lighter socket are not connected.
5.4 Program description
The online help for the KTS 200 control unit diagnosis soft-
ware is opened under “Menu >> Help” in the soft key bar.
Basic information about the KTS 200 and ESI[tronic]
Startcenter can be found under “ESI[tronic] trainer” in
the ESI[tronic] Startcenter software.
R
R
R
R
0
0
0
en