Antenna Connection
This unit is designed for connection to various antenna systems as described below.
CAUTION: For external antennas, use No. 8 AWG aluminum wire, or larger, as ground wires for both mast and lead-in,
and secure to building structure with insulators spaced 4 to 6 feet apart. Mount antenna discharge unit as closely as possible
to where the lead-in enters the building.
External FM Antenna. If installing a standard 300-ohm antenna system,connect the two wires from the‘T’ antenna to
the screw terminals marked 300-ohm. At the same time, remove any jumper wires connected to these terminals. If
conditions require the use of a coaxial transmission line, such as RG-11 or RG-59, connect the coaxial transmission line
to the screw terminals marked 75-ohm.
Always disconnect any jumper wire connected to the 300-ohm terminals when using an
external FM antenna.
AM Loopstick Antenna - Use an external AM antenna for AM reception.
1. Carefully pull the antenna lead from the holding notch in the antenna and unwind the lead
from the loop.
2. Connect the antenna leads to the terminals marked AM ANT.
3. Fold the antenna so that it snaps into the base forming a free-standing unit (see diagram).
4. Position the antenna for best reception. If desired, the antenna may be permanently
mounted using screws through the two holes in the base.
This Lucent Technologies AM/FM Tuner incorporates the latest in PLL digital circuitry for reliable performance for years
to come.
Description
Your carton contains:
* Digital AM/FM Tuner unit
* FM Antenna
* AM Loop Antenna
* Stereo-to-mono Cable
* Mono-to-mono male RCA Cable
Package Contents
Digital AM / FM Tuner
BOGEN
RAMSEY, N.J.
COMMUNICATIONS
that may cause undesired operation.
(2) this device must accept any interference
may not cause harmful interference, and
following two conditions: (1) this device
FCC Rules. Operation is subject to the
This device complies with Part 15 of the
MODEL TP-30D
60 Hz/4W
120 VAC
O
U
T
P
U
T
L
R
BAL
300 OHM
ANT
AM
75 OHM
connector
panel
AM LOOP ANTENNA
Page 3 of 4