Filter
Top Products
13
CHAPTER 3: Installation
Figure 3-3. Aligning the Tab.
4. Connect the headset to the
bottom of the remote. Insert
the remote into the base
(see Figure 3-4). Either side
may be used. The battery
charge indicator marked
with the 5 icon on the
base will light up. This will
be referred to as the front of
the base. Fully charge the
remote for 3 hours before
using.
Figure 3-4. Connecting the Headset.
3.2 Checking the System
Put the system in headset mode by
pressing once on the headset/
handset selector on top of the
base. The on-line indicator
marked on the base with the 4
icon will light. After 5 to 45
seconds, the on-line indicator on
the top of the remote will start to
flash (the base searches for an
open transmission channel only
on the first time). The system is
now working. If the on-line
indicator does not flash, recheck
assembly (Figure 3-5).
Figure 3-5. Checking the Assembly.
3.3 Charging the Battery
The nickel-metal-hydride battery
(NiMH) for the remote is not
charged when delivered. To
charge, place the remote with the
battery in the base for at least 3
hours before making the
adjustments below.