Filter
Top Products
Set surround mode operation - Most users will prefer the factory setting - AUTO. In this mode the receiver
automatically sets the surround mode to full 7.1 channel operation (or as many as permitted by your speaker
setup) whenever a Dolby Digital or DTS bitstream is detected regardless of what surround
mode you have
selected. For example, load your CD changer with a normal PCM CD, a DTS CD, and another normal PCM CD
and select audio mode SURROUND 3 (see AUDIO MODES above). While the PCM CD is playing you will get
sound from the front and center speakers only. When the disc changes to the DTS CD you will get sound from all
front, center, and surround speakers. When the third (PCM) CD starts the receiver returns to SURROUND 3. Note
that if a Dolby Digital or DTS source is currently playing and you change the audio mode the receiver will stay in
the selected audio mode until you select another input or turn the receiver off and on. In MANUAL mode the
chosen audio mode remains set regardless of the bitstream detected
. In the above example only the front and
center speakers would be used on all three CDs even though the DTS CD was capable of providing full 5 channel
sound to 7.1 speakers. Note that the surround channel information is not lost. It is simply mixed into the front
speakers.
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Dis
p
la
y
Enabled
4 V1 Out
p
ut Ta
p
e
5 Surround Modes Auto
S
y
stem will choose surround
mode based on user in
p
ut and
data from source material
next item ad
j
ust
MENU advanced setu
p
5 Surround Modes Auto
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Dis
p
la
y
Enabled
4 V1 Out
p
ut Line
5 Surround Modes Manual
User will make all surround
mode selections manuall
y
next item ad
j
ust
MENU advanced setu
p
5 Surround Modes Manual
return to ADVANCED SYSTEM SETUP
∠ MENU
MENU3
set to Auto or ManualVOLUME KNOB
(REW) or
(FF)
2
move to Surround Modes
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Zone 2 Setup (B)
Configuration will allow you to fix and set maximum volume level, remote control ‘Zone’ ID, V2 tape mode for Zone
2 (B). Additionally, there are options to set the linking of Zone 2 (B) to Zone 1 (A). Make sure you are in the
ADVANCED SYSTEM SETUP menu and the remote is in B&K mode.
ADVANCED SYSTEM SETUP
1 Zone 1 Setu
p
'A'
2 Zone 2 Setu
p
'B'
3 Power On Titles
4 Control Out
5 Securit
y
O
p
tions
6 DSP Usa
g
e
7 RS-232 Control Port
next item SEL select
MENU setu
p
s
y
stem
2 Zone 2 Setu
p
'B'
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Out
p
ut Ta
p
e
5 Link In
p
ut to Zone A No
6 Link Power to Zone A No
next item ad
j
ust
MENU advanced setu
p
1 Level Control Variable
64
p/n 12858 Rev. 0717A