Filter
Top Products
CHOOSING A SOURCE
In general, the selected source will appear at the Zone 1 (A) output, the TAPE output, and the V1 output. To
prevent feedback, TAPE input will not appear at TAPE output and V1 input will not appear at V1 output.
DVD Surround 7 EQ Variable
DVD 5.1 48k Both Video
return control to receiver if desiredB&K
select desired source - remote now controls source
(SOURCE) step to sourcedesired source
(press twice)
ActionFrom Front PanelFrom Remote
Note: if your source has separate ON and OFF control like your receiver, pressing the source button twice will also
turn on that source. If not, you will have to hit POWER while the remote is still set to the desired source.
TAPE MONITOR - If you have an analog three-head cassette or reel-to-reel analog tape recorder you may wish to
use TAPE MONITOR, which allows you to hear exactly what is on the tape as you are recording.
TAPE Stereo 7 EQ Variable
Analo
g
2.0 96k Both Video
select TAPE monitor
TAPE will appear on Zone 1 (A) out
(SOURCE) step quickly to TAPE
TAPE
(press twice)
wait a few seconds while receiver analyzes
selected source
select desired source or TUNER
source will appear on TAPE and V1 outs
(SOURCE) step to source
desired source
(press twice)
ActionFrom Front PanelFrom Remote
Note: The tape monitor loop only allows recording of analog inputs. If you simply choose the source you wish to
tape without
then selecting TAPE MONITOR then you can make analog recordings of digital inputs as well as
analog inputs.
AM/FM TUNER
TUNER Stereo 7 EQ Variable
FM 102.5 2.0 96k Both Video
set FM stereo/mono
↵ (ENTER)
SEL or ENTER
4
manually tune up or down to desired frequency
see AM/FM TUNER SETTING for DIRECT / SEEK /
TUNE
∧ (UP) or ∨ (DOWN)
TUNE+ or TUNE-
3
select desired TUNER Band (SOURCE) step to AM or
FM
AM or FM
2
make sure remote is in B&K modeB&K
1
ActionFrom Front PanelFrom Remote
Note: For a few seconds after performing any tuner operation ( AM, FM, or TUNE+/-) you may directly enter a
frequency from the remote control’s numeric keypad. The MONO or ST audio mode buttons on the remote control
and select mono/stereo.
47
p/n 12858 Rev. 0717A