Filter
Top Products
10
REAR PANEL
The receiver’s back panel is organized into groups of inputs and outputs for audio and video as shown below. See
back of this manual for an enlarged view.
V1 TUNER
FM antenna
DVD/VLDTAPEZ2/V2 V2CDTAPEZ2 TV-V3SATV1Z1
FRONT R
LBACK
RSURR
CENTERV1V2TV-V3
RS-232
IR IN
Z1
Z24
SURROUND OUTPUTS
3
CONTROL OUTPUTSDIGITAL OUTPUTS
OPTICAL 3.5mmCOAX 1 2
V1V2DVDCDSAT
AC LINE
FUSE
CAUTION:FOR CONTINUED
PROTECTIONAGAINST RISK
OFFIRE REPLACEONLYWITH
SAMETYPE 12A,250V FUSE
ATTENTION
DANGER D'ELECTROCUTION
NE PAS OUVRIR
DANGER D'ELECTROCUTION
NE
PASOUVRIR
CAUTION
RISK OF ELECTRICSHOCK
DO NOT OPEN
RISK OF ELECTRICSHOCK
DO
NOT OPEN
AM antenna
LINE INPUTSLINE OUTPUTSZONE OUTPUTS
FRONT L
RBACK
LSURR
DVD/VLDCDSAT
SUB
B&KComponents,Ltd.
A/VSystemsmade inthe U.S.A.
V3
3.5mm
COAX INPUT
OPTICAL DIGITAL INPUTS
COAX DIGITAL INPUTS
ManufacturedunderlicensefromDolbyLaboratories.
“Dolby”,“ProLogic”andthedouble-DsymbolaretrademarksofDolbyLaboratories.
Confidential Unpublished Works. 1992-1997 Dolby Laboratories, Inc. All rights reserved.ã
PLUSMINUSPLUSMINUS PLUSMINUS PLUSMINUS PLUSMINUS
CENTERREAR RIGHT REAR LEFT FRONT RIGHT FRONT LEFT
SERIAL NUMBER
12VDC
50mA
+
COMPLIESWITH THE
LIMITS
FORA CLASSB COMPUTING
DEVICEPURSUANT TO
1 2
3
4 5
7
8
9
1011121415 13 6
1. AC fuse holder - Holds the AC Line fuse. Replace only with same type and value.
2. AC input receptacle - For attaching the supplied AC power cord to the receiver.
3. RS-232 input - Computer interface applications.
4. Speaker outputs - Connections for your speakers.
Red binding posts - speakers (+)
Black binding posts - speakers (-)
5. Serial number - The serial number is located on the back of your unit.
6. Antenna inputs - Connections for the AM and FM antennas.
7. Line inputs - Connections from your audio/video sources.
Red RCA jacks - right analog audio
White RCA jacks - left analog audio
Yellow RCA jacks - composite video
4 pin din jacks - S-video
8. Line level outputs - Fixed level outputs to an audio or video recorder.
9. Zone 1 (A) and Zone 2 (B) A/V outputs - Variable level outputs for use with external amplifiers and video
outputs for use with video monitors.
10. IR in - Accepts input from external IR receptors. Connect an IR repeater (“home run”) to IR IN for controlling
the receiver. This method of control is useful when the front IR receptor is blocked (for example, by a cabinet
door) or to control the receiver from another room. This input is typically used in place of an emitter attached to
the front panel.