Filter
Top Products
SURROUND MODES
Your receiver provides a number of listening modes. The following table shows how your receiver responds to the
chosen surround mode setting for various types of source material. The table assumes five full range speakers
plus a subwoofer. If your speaker configuration is different from this make sure you have performed the set up
procedures described previously. When the setup is correctly performed your receiver will automatically route
audio to fewer/smaller speakers with no loss of information. If you wish to temporarily reduce the number of
speakers you are using do not repeat the setup procedure - simply choose the appropriate surround mode.
L-M M R-M
L-R L-R
M L R LF C RF
LR LFE RR
M
M LF+LR C RF+RR
LFE
M M LF+C RF+C
LR LFE RR
M M
M M
LF+C+LR RF+C+RR
LF+C+LR
LFE
RF+C+RR
M M
LF+C+LR RF+C+RR
LFE
L RM M
M M
Mono
Stereo
Pro Logic
Dolby Digital 2.0
Dolby Digital 2.0
(Stereo)
Dolby Digital 5.1
DTS 5.1
Surround
3 Stereo
Hall
3 Stereo
Stereo
Hall
Stereo
F/R
Stereo
Stereo
Lt Rt
Headphone
L R
LF+C+LR
+LFE
RF+C+RR
+LFE
L-M M R-M
L-R L-R
L-M M R-M
L R
L-R L-R
L R
L R
L R
L R
L R
L-M M R-M
L-R L-R
L-M M R-M
L R
L-R L-R
L R
L R
L R
LF C RF
LR LFE RR
LF+C+LFE
+(LR+RR)
RF+C+LFE
-(LR+RR)
M - mono, same information on both channels of analog, PCM, or Dolby Digital 2.0 bitstream
L - left channel of stereo information of analog, PCM, or Dolby Digital 2.0 bitstream
R - right channel of stereo information of analog, PCM, or Dolby Digital 2.0 bitstream
LF - left front channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
C - center channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
RF - right front channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
RR - right rear channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
LR - left rear channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
LFE - low frequency effects channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
34
p/n 12699 Rev. 9808B