Filter
Top Products
20
7. To avoid popping, try holding the microphone at a slight angle below your mouth.
8. To avoid covering the integrated antenna by your hand, do not hold the microphone at
the microphone head as this could reduce the transmission strength. Furthermore, feedback
can occur.
2.3 Maintenance
Protect the microphone from humidity, knocks and shock. Avoid dropping the micro-
phone at all times.
If your microphone sounds dull, clean the integrated foam pop shield. To do this, follow the
instructions below.
• SDM 169: Unscrew the microphone upper basket counter clockwise.
SDM 159, SEM 181: Unscrew the whole microphone basket clockwise.
• Pull out the foam pop shield and clean it under clear running water. If necessary, use a mild
washing-up liquid. Dry it afterwards with a hairdryer or allow it to dry overnight.
• Place the dry pop shield inside the microphone basket and replace the microphone basket
by screwing it on clockwise or counter clockwise.
3. TS 100 Beltpack Transmitter
3.1 Controls and Indicators
(1) Mute switch
(2) red Peak LED (audio)
(3) Gain control (audio)
(4) Connection for microphones / instruments,
3.5 mm stereo jack (female), screw-type
(5) green Power On battery condition LED
(6) On / Off switch
(7) Antenna
(8) Battery compartment
3.2 Setting up
1. Open the battery compartment (8) by pulling the cover downwards. Insert a 9 V alkaline
battery or rechargeable battery observing the polarity +/- marks.
On
Mute
(1) (2) (3) (4) (5) (6)
Off
Peak
Vol Batt
On Off
Power
Opus
TS 100 V
VHF Transmitter
(7)
(8)