Filter
Top Products
18
VIRTUALIZER PRO DSP1024P
Connect the two Input phone jacks with the Aux Send outputs of the mixing console, and the Output jacks of
the VIRTUALIZERPRO with the Aux Return inputs of the console. If you want to use the BEHRINGER
VIRTUALIZERPRO in mono or dual mode, connect one audio channel (left or right) to one aux bus.
+ Turn down the volume on your amplifier to protect your equipment against damage. All
devices you wish to interconnect should remain switched off until they are wired correctly.
Lets suppose you wish to use the VIRTUALIZERPRO in a live application, interfaced with the F.O.H. mixer,
to enhance the guitar sound with a subtle chorus effect.
Connect the VIRTUALIZERPRO to the aux bus of your mixing console (fig. 3.1). Connect the units to the
mains and adjust the operating level(s) if necessary. Switch on the VIRTUALIZERPRO and set the levels
appropriately (see 3.1). Press the Mix combination to make sure that the unit is set to Mix External mode.
Press the EFFECT key and use the JOG WHEEL to select and thus activate the chorus effect (#19). Slowly
turn up the aux bus level until the effect portion added to the guitar signal suits your needs. Subsequently, you
can make all necessary fine-adjustments. We assume that you wish to edit the modulation frequency of the
chorus effect: press the VARIATION key and set the modulation frequency with the JOG WHEEL. To set the
modulation delay, press the EDITA key. The modulation depth of the chorus effect can be set by pressing the
EDITB key. Having edited all parameters as desired, you can save the changes to the original (or any other)
preset.
3.3 Using the VIRTUALIZERPRO in the insert path
Basically, you can also insert the VIRTUALIZERPRO in a channel or subgroup of your mixing console. Use a
dedicated insert cable. Inserting the VIRTUALIZERPRO in a single channel will be useful only if you wish to
process a specific signal (e.g. vocals) with the VIRTUALIZERPRO, or if any other insert facilities of your
mixing console are already in use.